IPM TECHNOLOGY SDN BHD
17, Jalan Riang 20,
Kawasan Perindustrian
Taman Gembira,
81200, Johor Bahru,
Johor, Malaysia.
17, Jalan Riang 20,
Kawasan Perindustrian
Taman Gembira,
81200, Johor Bahru,
Johor, Malaysia.
+607-333 6011/6012/6013
+6012-603 6003
+6016-710 6015
+6012-603 6003
+6016-710 6015
+607-330 5686
MVL-25
Previous | 7 / 9 | Next |
MODEL | UNIT | MVL-25 | |
Capacity | Max. Swing Diameter | mm (Inch) | Ø3,000(118.11) |
Max. Turning Diameter | mm (Inch) | Ø3,000(118.11) | |
Distance From Bite Holder End To Table Surface | mm (Inch) | 0 ̴ 2,230 (0 ̴ 87.79) | |
Max. Turning Height | mm (Inch) | 2,180 (85.82) | |
Max. Workplace Weight | kg | 20,000 | |
Table | Table Diameter (Manual Chuck) | mm (Inch) | Ø 2,500 (98.42) |
Range Of Table Speed (Low) | rpm | 8 ̴ 30 | |
Range Of Table Speed (High) | rpm | 31 ̴ 120 | |
Gear Speed | steps | 2 | |
Max. Of Table Torque | N.m | 89,400 | |
ATC | ATC (Automatic Tool Changer) | set | 1 |
Number Of Tool Stations | Random | 12 | |
Tool Type | T-Puller | ||
Tool Size | mm (Inch) | 25 / 32 / 40 (1” / 1.25” /1.5”) | |
Cross Section Of Ram | mm (Inch) | 300 x 300 (11.81 x 11.81) | |
Travel | Horizontal Travel (X-Axis) | mm (Inch) | -1,520+1,720(-59.84+67.71),ref point |
Vertical Travel (Z-Axis) | mm (Inch) | 1,200 (47.24) | |
Cross Rail Travel | mm (Inch) | 1,400 (55.10), 5step (6 positions) | |
Feed Rates | Rapid Rate (X-Axis) | m/min | 10 |
Rapid Rate (Z-Axis) | m/min | 10 | |
Cutting Feed Rate | mm/rev | 0.001 ~ 500 | |
Feed Overide | % | 0 ̴ 150 | |
Motor | Table Main Motor | kW (HP) | ᾳ60HVi, 60 /75 (80.4/100.5) |
Feed Servo Motor (X Axis) | kW (HP) | ᾳ30i 7 (9.4) | |
Feed Servo Motor (Z Axis) | kW (HP) | ᾳ30Bi 7 (9.4) | |
Milling Spindle Motor | kW (HP) | - | |
Cf Axis Motor | kW (HP) | - | |
General | Machine Height | mm | 7,750 |
Floor Space (L x W) | mm | 8,810 x 6,000 | |
Machine Weight | kgs | 55,000 | |
•Specification is subject to change without further notice. |